Radio Frequency Tracer

The FC6002 radio frequency tracer is useful in locating stuck transmitters or bugging devices in a room or automobile. It excels at silent detecting RF signals for RF security and counter-surveillance applications. Supplied as a complete with internal NiCd pack, AC wall charger, 7 section telescopic antenna and earphone.

Controls

• SEN Knob - This knob turns the tracer on and adjusts sensitivity.V
• IBRATION Switch- This switch selects the tone or vibration alert output.

• Pocket size
• Built-in speaker to output alert tone
• Vibration motor and earphone for silent detection
• 5 section RSSI bargraph to show relative RF signal strength
• Low power consumption (Average 8 hour battery life)
• Supplied with NiCd pack, AC wall charger, 7 section telescopic antenna and earphone

Specifications

• Frequency range: 1 MHz - 3 GHz
• Impedance: 50 Ohms (BNC Socket)
• Case: Stamped aluminum with black anodized finish
• Battery: Internal 5 x AA 600 mAH NiCd pack
• Power: 9 VDC 300 mA
• Weight: 230g
• Size: 100 mm high x 68 mm wide x 31 mm deep

Battery

• This tracer can operate for up to eight hours from its fully charged NiCd batteries. They are charged when the unit is plugged into the supplied AC/DC adapter. Full recharge will occur over 12 to 16 hours. Before recharging the batteries you should be deep cycled occasionally by allowing them to completely discharge to maintain maximum battery capacity. The NiCd batteries should last for several years. However, it is a good idea to check them every twelve months for signs of corrosion or leakage. Always replace the whole set if any one cell fails.

Warranty

• Circuit Specialists, Inc. guarantees the tracer and accessories for one year against defects in manufacture. This warranty does not cover items that have been modified, subject to unauthorized repairs, misuse or abuse. This warranty does not cover damage caused by excessive power levels 15 dBm applied to the signal input